Transponder types (immobilser chips in keys)
Connect from 2003-2006 uses ID4D-60 (Glass) as shown below
Connect from 2006-2013 uses ID4D-63 (W1 carbon chip) as shown below
A 3 button remote key can also be programmed to connects for remote central locking & PATS (immobilser)
make sure you get the correct one for your connect - see below
Blank key blade are available from Ford for £8 - they will even cut it for you
Coding transponder/keys to PATS on connects from 2003-2009
**NOTE** :- A maximum of eight keys (including the ones supplied with the vehicle)
Can be coded using two other keys previously coded for your vehicle.
Complete the following steps within five seconds.
1. Insert the first key in the ignition switch and turn to position II.
2. Turn the key back to position 0 and remove from the ignition switch.
3. Insert the second key in the ignition switch and turn to position II.
4. Turn the second key back to position 0 and remove from the ignition switch − the key coding mode is now activated.
5. If an uncoded key is now inserted in the ignition switch and turned to position II within 10 seconds, this key is coded to the system.
6. After the coding process is completed, remove the key from the ignition switch. Wait five seconds for the system to be activated.
If coding is not completed correctly, the indicator light flashes after the ignition is switched on with the newly coded key and the engine will not start.
Repeat the coding process after waiting 20 seconds with the ignition switched on (position II).
Programming 3 button romote key/fob for remote central locking on connects from 2003-2009
1. Close all the doors.
2. Turn Ignition key from position 0 to II eight times within 10 seconds.
3. Locks will cycle (locks then unlocks the doors.)
4. Press the button on the remote fob / 3 button key within 20 seconds, the locks will cycle again (locks then unlocks)
7. Turn the ignition key to position 0 to exit the programming mode.
**NOTE** : Maximum 4 remote fobs/keys may be programmed.
Programming 3 button remote key/fob for remote central locking on connects from 2009-2013
1. Turn ignition key to position II four times within six seconds.
2. Turn the ignition to position 0. A tone sounds to indicate that it is now possible to programme the remote controls for ten seconds.
3. Press any button on a new remote control. A tone will sound as confirmation.
4. Repeat this last step for all your remote controls, including your original. Do not remove the key from the ignition when pressing the button on this remote control.
5. Switch the ignition back on (position II) or wait for ten seconds without programming another remote control to end the key programming.
Only the remote controls which you have just programmed are now able to lock and unlock the vehicle.